Customer Also Bought
Nitromors All Purpose Paint and Varnish Remover
Removes paint, varnish and lacquers from wood, masonry and metal.
Features and Highlights
- A fast acting all purpose paint and varnish remover
- Removes layers of paint, varnish and lacquer from wood, metal and masonry
- Super strength formula for concentrated action and fewer applications
- Non-drip gel formulation - ideal for vertical surfaces
- Removes up to 15 layers with just 2-3 applications
- Very High V.O.C
| Brand | Nitromors |
|---|---|
| No. of coats | 2-3 |
| Coverage | Up to 2.5 m² per litre |
| Size | 375ml, 750ml, 2L |
| MPN | Please Select Size/Option |
| GTIN | Please Select Size/Option |
Overview
Nitromors All Purpose Paint and Varnish Remover is a fast acting, double strength, all purpose remover for stripping layers of paint, varnish and lacquer. The green coloured, non-drip gel is easy to see and perfect for stripping vertical surfaces. It gives excellent coverage and strips up-to twice the paint layers. Fast acting formula blisters top coats within five minutes.
Please Note: This product is not suitable for use on plastic surfaces and should not come into contact with any plastics.
Preparation
Ensure that surfaces to be stripped are clean and dry to maximise the performance of this product. Brush down with a stiff brush to remove surface dirt and debris if required.
Wear protective clothing when applying this product and avoid contact with skin and eyes. Ensure adequate ventilation when using this product and especially so in confined spaces.
Application
Always do a test area before starting any project to assess product suitability and performance. Follow the manufacturer's instructions on the tin at all times.
- Decant Nitromors Paint & Varnish Remover into a suitable glass or metal container
- Work in small areas of no greater than 0.5 square metre, ideally out of direct sunlight
- Apply a thick coat by brush with a dabbing action, ideally 2-3mm thick and do not brush out
- Wait until the paint has blistered (usually about 10 minutes) and then apply another coat, this time working Nitromors remover into the blistered paint
- Leave up to 40 minutes but do not allow to dry out
- Apply more remover if necessary
- To minimise contact with vapours, leave work area between applications
- Remove blistered or softened paint with a stripping knife
- Use a shavehook or old nylon toothbrush in difficult areas such as corners, rebates and beading
- Remove traces of stubborn or ingrained paint by rubbing with coarse wire wool dipped in Nitromors
- If any paint remains repeat the above process
- Wash down with liquid detergent in cold water (use white spirit on fine woods to avoid raising the grain), then rub down with fine wire wool dipped in the water or white spirit
- Allow to dry thoroughly
- Rub down with either fine sandpaper, wire wool or other abrasive
Please note: The use of wire wool or steel wool is not recommended on Oak as it can blacken the wood
Back
