Zinsser AllCoat Exterior Satin (Water Based)

Zinsser AllCoat Exterior Satin (WB) is a high quality exterior paint for long lasting protection on surfaces such as wood, concrete, masonry, metal, cladding, UPVC and much more. A self priming paint which can be applied to previously painted surface without the need for sanding, including surfaces coated with bitumen, tar varnish and creosote. A low maintenance coating offering a 15 year lifetime guarantee.

• For an alternative sheen you can try either Zinsser AllCoat Exterior Gloss (Water Based) or Zinsser AllCoat Exterior Matt (Water Based).
• Looking for a solvent-based exterior paint? Try either Zinsser AllCoat Exterior Gloss (Solvent Based) or Zinsser AllCoat Exterior Satin (Solvent Based).

To get the best results, ensure surfaces to be painted are sound, clean and dry (new surfaces particularly must be fully dry), and free from all defective or poorly adhering material, dirt, grease and chalky residue. Sand all edges of remaining coating until smooth.

Previously Painted Surfaces

1. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead
2. Remove and treat any mould and mildew on exterior surfaces using Zinsser Mould Killer and Remover
3. Timber surfaces at risk of decay or insect infestation should be treated with an appropriate Wood Preservative before coating
4. Extremely hard or glossy surfaces will need to be sanded and degreased before paint application

Bare or New Surfaces

1. Fill any cracks and nail holes in wood surfaces using an appropriate wood filler
2. Spot prime any knots and resin streaks using Zinsser B-I-N or Zinsser Cover Stain for resinous woods, such as cedar and redwood
3. Surfaces such as concrete and masonry must be fully cured for at least 30 days before coating

Always do a test area before starting any project to assess product suitability and final finish. Follow the manufacturer's instructions on the tin at all times.

Only apply at temperatures ranging between 10°C and 32°C and a relative humidity of no more than 85%.

1. Stir thoroughly before and periodically during use
2. Apply evenly and consistently, to maintain a 'wet edge', using a good quality synthetic bristle brush, microfibre roller or low pressure spray gun (Use tip size 0.017 at pressure 2000 - 2500 psi)
3. It is recommended that 2 coats of Zinsser AllCoat Exterior are applied, with additional coats to areas of high exposure, such as sills and fascia boards
4. Allow to fully dry for 1 hour between coats

Cleaning Equipment

Clean brushes, rollers and any spillages immediately after use, using warm soapy water.

Yes absolutely, Zinsser AllCoat is a multi-surface paint and suitable for a wide range of projects.

Absolutely, the Zinsser Allcoat is a multi-purpose paint, offering self-priming and adhesion to many surfaces including metal, masonry, plastic, concrete, cladding and more.

Exterior paints tend to be rather flexible to cope with the expansion and contraction of the timber. Internal timber doesn't need this flexibility and movement, but it does need more durability than an exterior paint due to a higher risk of wear and tear/ scuffs and scrapes. For a similar quality paint, offering the benefits of multi-surface use with no primer or undercoat needed, take a look at Bedec MSP Multi Surface Paint. This comes in white gloss and is non-yellowing.

A 1L would cover this project. Be sure that the surface is cleaned thoroughly before use by using Zinsser Universal Degreaser and Cleaner.