Zinsser AllCoat Exterior Gloss (Solvent Based)

Zinsser AllCoat Exterior Gloss (SB) is a high quality exterior gloss paint for long lasting protection on surfaces such as wood, concrete, masonry, metal, cladding, UPVC and much more. A self priming paint which can be applied to previously painted surface without the need for sanding, including surfaces coated with bitumen, tar, varnish, and creosote. A low maintenance coating offering a 15 year lifetime guarantee.

• Looking for a satin sheen? Try Zinsser AllCoat Exterior Satin (Solvent Based)
• Looking for a water-based exterior paint? Try Zinsser AllCoat Exterior Gloss (Water Based), Zinsser AllCoat Exterior Matt (Water Based) or Zinsser AllCoat Exterior Satin (Water Based).

To get the best results, ensure surfaces to be painted are sound, clean and dry (new surfaces particularly must be fully dry), and free from all defective or poorly adhering material, dirt, grease, and chalky residue. Sand all edges of remaining coating until smooth.

Previously Painted Surfaces

1. The moisture content of the substrate should not exceed 12% prior to coating.
2. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead
3. Remove and treat any mould and mildew on exterior surfaces with a suitable mould and mildew cleaner
4. Timber surfaces at risk of decay or insect infestation should be treated with an appropriate Wood Preservative before coating
5. Extremely hard or glossy surfaces will need to be sanded and degreased before paint application

Bare or New Surfaces

1. Fill any cracks and nail holes in wood surfaces using an appropriate wood filler
2. For all wood surfaces, treat any knots and resin streaks using Zinsser B-I-N and prime the surface using Zinsser Cover Stain
3. Surfaces such as concrete and masonry must be fully cured for at 30 days before coating
4. Brick, masonry, concrete, metal and UPVC surfaces should be primed using Zinsser Bulls Eye 1-2-3 prior to painting

Always do a test area before starting any project to assess product suitability and final finish. Follow the manufacturer's instructions on the tin at all times.

Only apply at temperatures ranging between 5°C and 32°C and a relative humidity of no more than 85%.

1. Stir thoroughly before and periodically during use
2. Apply evenly and consistently, to maintain a 'wet edge', using a good quality synthetic bristle brush, microfibre roller or low pressure spray gun (Use tip size 0.13 - 0.017 at pressure 1800 - 2400 psi)
3. It is recommended that 2 coats of Zinsser AllCoat Exterior are applied, with additional coats to areas of high exposure, such as sills and fascia boards
4. Allow to fully dry for 16 hours between coats

Thinning Guidelines

• Normal use: Thinning is not required
• Conventional and Airless spray application (not to be exceeded): Add up to 10% of white spirit

Cleaning Equipment

Clean brushes and rollers immediately after use, using white spirit. For dried on paint, use Zinsser B-I-N Brush Cleaner and Restorer.