Manns Trade Shellac Sanding Sealer

Ensure that the surface to be sealed is clean, dry and free from dirt, dust, grease or any other surface contaminants. Proper preparation is essential to achieve maximum adhesion and a smooth, even finish.

1. Surfaces should be untreated, bare wood. Any existing paints, varnishes, waxes or previous finishes must be completely removed by thorough sanding or with a dedicated wood stripper.
2. Sand the surface evenly in the direction of the wood grain using a suitable abrasive to create a smooth, level base. Remove all sanding dust carefully using a vacuum or lint-free cloth.
3. Fill any larger gaps, cracks or surface imperfections with a suitable wood filler and allow it to fully dry before sanding smooth.
4. Ensure the timber is fully dry before application. Do not apply to damp wood, as this can affect adhesion and final finish quality.
5. Before full application, test the product on a small, inconspicuous area to confirm compatibility and the desired appearance.

Softwood surfaces can be stained prior to sealing with Manns Classic Pine Stain or Manns Classic Oak Stain for Oak and other hardwoods. If a solvent-based stain is preferred, use Manns Trade Light Fast Wood Stain.

Always do a test area before starting any project to assess product suitability and final finish. Follow the manufacturer's instructions on the container at all times. Shake well before use. This product can be thinned down with methylated spirits if required to achieve the desired consistency.

1. Ensure the surface is clean, dry and free from dust, grease and any previous finishes that may affect adhesion. Lightly sand if required and remove all sanding dust before application.
2. Apply the sanding sealer with a good quality bristle blend brush, working in the direction of the wood grain and covering roughly half a square metre at a time. For larger, flat areas, a short pile microfibre roller can be used to achieve quick, even coverage.
3. Apply thin, even coats and avoid overworking the product, as shellac dries rapidly. Do not apply excessively thick coats.
4. Allow approximately 30 minutes drying time between coats under normal conditions.
5. De-nib (lightly sand) between coats using a fine abrasive to remove any raised grain, then remove all dust before applying further coats or the chosen topcoat.

Once fully dry, Manns Trade Shellac Sanding Sealer can be overcoated with a suitable french polish or wax.