Ronseal One Coat Wood Primer and Undercoat

Ronseal One Coat Wood Primer and Undercoat is for use on bare and previously painted interior wood surfaces. It is ideal for skirting boards and architraves, only requires one coat and dries in just 2 hours ready for over-coating.

• Looking for a primer and undercoat for other interior surfaces? Try Ronseal One Coat All Surface Primer and Undercoat
• Looking for a primer that stops wood knots showing through? Use Ronseal Knot Block Wood Primer and Undercoat
• Looking for an all-in-one paint and primer? Try Ronseal Stays White 2 in 1 Primer and Paint
• For exterior surfaces, use Ronseal All Surface Primer and Undercoat - Exterior

Ensure that surfaces to be primed are clean, dry, and free from any dirt, dust or other surface contaminants. Make sure room temperature is above 10°c. Put down dust sheets to protect areas not to be painted.

Bare Wood

1. Lightly sand wood in the direction of the wood grain
2. Any old, decayed, loose wood must be removed before treating the affected area with Ronseal Wet Rot Wood Hardener prior to filling
3. Any existing woodworm can be eradicated with Ronseal Woodworm Killer
4. Fill any gaps in the wood with Ronseal High Performance Wood Filler or Ronseal Multi Purpose Wood Filler
5. Clean and degrease the wood by wiping over with a lint-free cloth dampened with white spirit prior to coating

Previously Painted Wood

1. If paint is in good condition, a light sanding is all that is needed
2. If paint is flaking, peeling or cracked, it must be taken back to bare wood by stripping or sanding
3. If the wood shows signs of rot or decay, follow the process above for 'Bare Wood'
4. Wipe down with white spirit, being sure to remove any excess sanding dust before applying Ronseal One Coat Wood Primer

Always do a small test area before beginning any project to assess adhesion and overall performance. Follow the manufacturer's instructions on the tin at all times. Stir thoroughly before use.

1. Apply Ronseal Wood Primer and Undercoat with a good quality synthetic brush or microfibre roller
2. Allow 2 hours to dry before applying a suitable top coat

Once fully dry, Ronseal One Coat Wood Primer and Undercoat can be overcoated with a suitable Ronseal top coat, such as Ronseal Stays White Ultra Tough Paint or Ronseal Stays White One Coat Non Drip Paint.

This should be fine however an extra coat may be required due to the nature of MDF.