|No. of coats
|Up to 10m² per litre
|Please Select Size/Option
|Please Select Size/Option
Bona Traffic GO combines the simplicity and efficiency of a 1K lacquer with the durability and performance of a true 2K product. With an innovative built-in hardener, Bona Traffic GO is ready to use straight from the can meeting high levels of durability it is versatile enough to be used in both commercial and domestic areas. It is especially suited for locations that experience heavy foot traffic.
Ensure that floors to be varnished are clean, dry, and free from all traces of dust, dirt, grit, oil, wax and any other surface contaminates before application.
Bona Traffic GO will normally have very good adhesion to pre-varnished flooring, however, it is advisable to check the intercoat adhesion prior to overcoating. To check intercoat adhesion, apply a coat of Bona Traffic GO to a pre-prepared area. Allow the coating to set for 3 days then scratch the treated floor surface gently with a coin. If the Bona Traffic finish stays firmly attached to the surface, the adhesion is satisfactory, and the main application can begin.
Floors pre-treated with waxes, polishes or other similar products cannot be overcoated with Bona Traffic GO and should be fully sanded back to bare wood to at least 120 grit, then primed with a suitable wood primer.
For bare, freshly sanded floors it is recommended to use a wood primer. Primers help with adhesion between the varnish and floor and can help with the colouration of the final finish.
|A ready-to-use primer for use with the Bona range of varnishes
|Bona Natural Primer
|Designed to preserve the impression of raw, untreated wood
|Bona Intense Primer
|A 100% polyurethane based primer for finishes requiring better adhesion
|Bona White Primer
|A high quality wood primer that creates a 'white-washed' effect on wood flooring
|Bona Amber Primer
|Wood primer for oak and darker tropical species of wood. GreenGuard approved
|Bona Classic UX Primer
|A forgiving primer with medium light wood colouration
Please note: Allow Bona traffic GO to reach room temperature before use.
Always do a test area before starting any project to assess product suitability and final finish. Shake well before use. Ensure room temperature does not fall below 13°C during application and drying. Thoroughly read and follow the manufacturer's instructions on the container at all times.
The following applicators are recommended for application of Bona Traffic GO:
|Bona Swivel Head Applicator
|A specialist 46cm floor applicator for professional floor finishers that is used in conjunction with the Bona Applicator Sleeve.
|Bona Lacquer Roller
|A synthetic, medium pile roller for the application of Bona varnishes.
Where a longer drying time is required due to high temperature and/or low humidity, Bona Retarder can be added to the varnish to increase the 'open time' of the product.
Please Note: If the previous layer of finish has been allowed more than 24 hours drying time then an intermediate sanding is always required. The floor will take light foot traffic approximately 8 hours after the final application and may be put into full use after 24 hours. Allow the surface to dry for at least three days before covering with carpets or other floor coverings. Also avoid placing heavy objects or damp mopping the floor during this time.
Lacquered floors should be dry swept or vacuumed on a regular basis to remove surface particles of grit, dirt and small stones that could scratch or mark the surface. Wooden floors should never be saturated with water or cleaned with household detergents or cleaners, as part of a regular cleaning routine, as these could significantly reduce longevity and performance of the floor varnish.
For more thorough cleaning and to remove surface scuffs and other marks, Bona have a range of pH-balanced floor cleaners and mops for the job. For regular cleaning the pre-mixed, ready-to-go formulas provide a quick solution whilst the concentrated products are good for scale of economy and deeper cleaning requirements.
|Bona Cleaner Concentrate
|A concentrated version of Bona Wood Floor Cleaner. Add water to clean up to 2,000 square meters of flooring per litre of concentrate
|Bona Premium Wood Floor Spray Mop
|An easy-to-use spray mop with changeable microfibre heads and cartridges
|Bona Wood Floor Cleaner Spray
|An everyday floor cleaner in a convenient 1L trigger spray bottle
To restore the appearance of Bona Traffic GO that has become dull or covered in minor scratches, the following products can be used.
|Bona Freshen Up
|A ready-to-use, maintenance coating to refresh the appearance of Bona Traffic GO
|Bona Wood Floor Refresher
|A durable and protective maintenance coat that is ready-to-use, offering extended protection against wear.
|Creates a durable wear layer for previously varnished floors. Available in both a Matt and Gloss finish
|Bona Wood Floor Polish
|A ready-to-use, water-based maintenance coating for previously varnished or painted wooden floors