Zinsser Cover Stain Aerosol

Zinsser Cover Stain Aerosol

How much will I need?
x
Enter area above for 1 coat (Recommended)

Wood type and application can vary coverage

£12.48
You can still order and we'll send your goods as soon they're in stock. You can also set up a stock email reminder
Quantity
FREE Delivery over £60.Order by 5pm for next day option*
A stain blocking aerosol spray, suitable for use on smoke and water damage. Touch dry in 35 minutes.

Features

  • A solvent-based, stain blocking primer and sealer in a convenient aerosol can
  • Effective treatment for stains including fire, smoke and water damage, nicotine and inks
  • Suitable for use on all interior and exterior surfaces, such as wood, plaster, metal, masonry, vinyl and more
  • Offers good resistance to cracking and peeling
  • Touch dry in 35 minutes, re-coatable in less than 2 hours
  • Compatible with all solvent and water-based topcoats
  • Very high V.O.C
Brand
Drying time
hrs
Coverage
Up to 9.8 m2 per litre
No. of coats
1-2
Size
390ml
MPN
Please Select Size/Option
GTIN
Please Select Size/Option

Overview

Overview

Back

Zinsser Cover Stain Aerosol is a quick drying coating for stains caused by fire smoke, water and nicotine on interior and exterior surfaces. Ideal for spot work on small areas on a range of surface, such as interior ceilings, walls door and furniture, and on exterior walls, doors, fascia's, soffits and railings. Will seal tanning bleed in cedar and redwood.

Please Note: When blocking stains caused by water or damp, make sure the original cause of the problem has been rectified.

Preparation

Preparation

Back

For the best results, ensure surfaces to be coated are sound, clean and dry and free from all defective or poorly adhering material such as dirt, grease, paint or adhesives. If needed, clean surface using an appropriate ammoniated cleaning solution. Never use tri sodium phosphate based cleaners.

  1. Take special precautions during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead
  2. Sand all edges of remaining coating until smooth
  3. Using an 80 - 100 grit sandpaper, lightly sand exterior timber to remove loose or weathered wood fibres and mill glaze
  4. Clean as much of the existing stain as possible, prior to priming
  5. Remove and treat any mould and mildew on interior surfaces using Zinsser Mould Killer and Remover
  6. Fill any nail holes and imperfections with a suitable multi-purpose filler and spot prime the area
  7. Spot prime any knots and resin streaks using Zinsser B-I-N
  8. All areas of rust should be cleaned using a wire brush

Application

Application

Back

Always do a test area before starting any project to check product suitability and effectiveness. Follow the manufacturer's instructions on the tin at all times.

Only apply at temperatures ranging between 5°C and 32°C and a relative humidity of no more than 85%.

  1. Shake can until it rattles, then holding the can upside down, continue to shake for 1 minute
  2. Shake periodically during use
  3. Hold can upright, 10 - 12 inches away from the surface, spraying horizontally using short, dusting strokes to ensure an even finish
  4. Apply 1 coat to prepared area. A second coat on very porous surfaces may be necessary
  5. Allow 2 hours between coats
  6. Fully cured 4 - 7 days

Cleaning Equipment

Turn the can upside down and spray for a few seconds, then wipe nozzle with a damp, lint-free cloth. To remove dried on primer, from surrounding areas use Zinsser B-I-N Brush Cleaner and Restorer.