Cascamite Wood Glue

Ensure the wood substrate is sound, smooth, level, clean, dry and free of any dust, dirt, wax, loose paint, incompatible curing compounds or fire retardant chemicals, fungicides, release agents, sealers, or any other foreign substances that might interfere with a good bond.

• Joints should be well fitted and smooth
• To avoid wood or joint fracture, ensure that both substrates to be bonded have no more than 3% difference in moisture content between them
• Any wood stored in cold temperatures should be brought above 10°C before applying the adhesive
• For dense timber like oak, sand the surface to open up the pores - applying a double spread of glue may be necessary to ensure both surfaces have sufficiently "wetted" out
• Wipe oily timbers down with methylated spirit to degrease the surface

Always do a test area before starting any project to assess product suitability and end result. Follow the manufacturer's guidelines on the container at all times, following any special precautions.

Do not apply in damp conditions, when rain is likely, or in temperatures below 10°C - between 15°C and 20°C is ideal.

1. Open the pail and removed desired quantity of powder adhesive, resealing the pail immediately
2. Add the powder to a suitable plastic container, do not use copper, iron brass or steel containers
3. Mixing by weight is recommended, at a ratio of 2 parts Cascamite powder to 1 part water, stirring continuously until all powder is dissolved
4. Up to 20% extra water can be added to improve the flow
5. Once mixed, allow the glue to stand for a short while to release any trapped air
6. Apply the adhesive using a strong bristled brush, to one surface only
7. Working time is around 3 hours at 15°C
8. If needed, clamp whilst the glue is wet using pins or screws, keeping the joint under pressure until it has set
9. Remove any excess adhesive with a lint-free cloth whilst the adhesive is still wet
10. Once it has hardened, it can be cleaned off mechanically
11. Tack time is 5 hours at 10°C, 2 hours at 20°C and 1 hour at 30°C
12. Curing time is 27 hours at 10 °C, 12 hours at 20°C and 3 hours at 30°C. Keep some leftover glue, when it's gone hard, this will indicate it's cured

Please note: If bonded wood is to be turned on a lathe, it is recommended the wood be seasoned for a minimum of one week before turning.

For a guide to press pressure on adhesive, please refer to the Technical Data Sheet supplied

Application equipment must be cleaned using cold water before the glue sets.

The Cascamite Wood Glue working time is 3 hours, It is fully cured in 27 hours and it will be at its hardest strength once cured.

Cascamite meets the EN 12765 C3 standard, which gives a good idea of how much stress it can handle. Here’s the simplified breakdown:
Standard dry conditions - at least 10 N/mm²
After 1 day in water at 20°C - at least 7 N/mm²
After hot‑water and cold‑water cycling - at least 4 N/mm²
These numbers describe the minimum stress per square millimetre the glue joint must withstand before failing in each test scenario. Important note Cascamite is a non‑structural adhesive.