Craig and Rose Artisan Concrete Effect

A water based interior paint used to create the effect of textured concrete to walls and ceilings. Suitable for elevating feature walls and producing a unique finish enabling the Artisan Concrete effect to create a minimal style and compliment a neutrally toned space

To accomplish the best results the surface needs to be clean, structurally stable and free of dirt, dust and surface impurities

• Remove all loose and defective paint by either using a paint scraper, paint stripper or sanding down the project area
• Special care should be taken if removing pre 1960s paint as this could contain harmful levels of lead
• Repair any defects such as cracks or holes with a suitable filler to produce a surface free of imperfections
• If necessary, sand the project area to produce a flat smooth surface
• If the project area shows signs of grease or oil, then wash with a suitable detergent and allow to dry thoroughly
• If using two or more tins from different batches, then blend the paint together in a large container to ensure a consistent hue and tone of colour
• Mask off the project area to protect the adjoining surfaces
• If Craig And Rose Artisan Concrete Effect is being applied onto either fresh plaster or a porous surface, then prime the area with a suitable primer, such as Craig And Rose 1829 All Purpose Undercoat

Always do a test area before starting any project to assess the suitability of the product and the finish.

Use only in well ventilated areas with a room temperature that will exceed 10ºC during the drying period.

• Practice the application technique on a large area beforehand, such as cardboard or a spare piece of board or wood
• It is advisable to work in small sections on the project area
• Initially, it is best to cut in around the edges with a paint brush
• Smooth the surface with a steel trowel in broad, sweeping strokes with the trowel at a 60° to 80° angle and ensure the trowel blade remains clean
• This process will need repeating over the entire project area to create a consistent coverage
• The standard procedure is to apply 3 coats following the above procedure, allowing a minimum of 4 hours drying time between coats. However, if the depth and appearance are to be increased then further coats can be applied
• Use a 600 grit sandpaper to apply a light polish once the final coat has dried but within 24 hours of the application
• It is optional, though advisable, to apply a further coating of a clear varnish to add an extra layer of protection to the concrete texture

Do not apply to highly absorbent surfaces

Cleaning

The treated surface can be gently cleaned with a damp cloth and a mild detergent. Avoid forceful scrubbing .