|No. of coats||1|
|Drying time||12 hrs|
Bona Titan is formulated with the new revolutionary titanium technology and is suitable for a wide range of wooden floor projects. It ensures proper cross-linking without the need to add a hardener or an external cross-linking agent.
The shear resistance bonding ensures a stabilisation of wooden floors, in particular solid elements. The fast initial bonding strength in combination with rigid adhesive ribs reduces the risk of hollow spots.
Please Note: Bona Titan is suitable in association with under floor heating. Such floors need to pass the heating up protocol to drying up the screed. During installation and three days after the screed temperature must not pass 25°C.
Looking for an adhesive for use on wooden stairs, skirting and door threshholds? Try Bona R880 Adhesive
The substrate must be even, totally dry, clean, free from cracks and physically sound. The surface should also be slightly textured. If applicable, it must meet the requirements of local standards or codes of practice. It should also be professionally prepared for laying.
Always do a test area before starting any project to assess product suitability. Follow the manufacturer's instructions on the container at all times.
Before use, ensure the air temperature is above 18°C, the floor temperature is above 15°C (with under floor heating max 20°C) and the relative humidity is less than 70%. If necessary, bring the adhesive to the right temperature.
Solid wood parquet should be slightly more humid whilst multi-layered or pre-finished parquet should be slightly drier. For example, in Central Europe average room conditions of 20°C and 50% relative air humidity can be expected. Pre-finished parquet shall have, on average 8%, solid parquet 9%. Typical deviations from the average are +/- 2%. Where doubts exist, avoid too dry material. Please also refer to the instructions for use provided by the parquet manufacturer.
Use a fine trowel for small pieces of wood and/or smooth substrates, and a coarse trowel for large pieces of wood and/or less smooth and rough surfaces (F = fine, G = coarse) Bona Adhesive Trowel
Please Note: Bona Titan can also be used for the installation of wood blocks RE (DIN 68702) with a maximum thickness of 30mm. Please get in contact with the Bona technical department before the installation.
It is possible to apply load and stress to the floor after approximately 24 hours. Pre-finished floors can be used carefully after 6 hours. Any sanding and surface coating to be applied, may be carried out after 12-24 hours depending on the type of parquet, absorbency of the substrate and room climate.