Woca Oil Refreshing Soap

Woca Oil Refreshing Soap is an effective cleaning and maintenance solution, which penetrates deep into the wood removing dirt, whilst re-oiling the oiled or waxed surface. Perfect for the upkeep and maintenance of floors previously treated with a natural or coloured oil/wax, white and extra white for white oiled/waxed wood floors.

• Looking for a spot cleaner to remove stains such as red wine and grease? Use Woca Wood Stain Remover
• For a read-to-use cleaning and maintenance solution, try Woca Oil Refreshing Soap Spray

Ensure areas to be treated are clean, dry and free of any loose dirt, grit or other surface contaminants by vacuuming or sweeping. Stubborn dirt and stains should be cleaned first using a Woca Intensive Wood Cleaner, Woca Intensive Wood Cleaner Spray or Woca Wood Stain Remover .

Always do a test area before starting any project to assess product suitability and final finish. Shake well before and during use. Ensure room temperature stays around 20°C during application and drying. Thoroughly read and follow the manufacturer's instructions on the container at all times.

1. For oiled floors, mix 250ml of Woca Oil Refreshing Soap with 5 litres of warm water
2. For UV-oiled and hard wax oiled floors, mix 125ml of Woca Oil Refreshing Soap with 5 litres of warm water
3. The measurements can be increased depending on the wear of the surface
4. Using a mop, clean floors in small manageable sections of 10m² to ensure complete coverage, following the woods natural grain
5. Rinse the mop thoroughly during cleaning to prevent dirt being re-applied to floors
6. Allow treated floors to completely dry for 2 hours before resuming normal use
7. If a light sheen is required, polish the dried surface with a cloth or buffing pad

Please Note: Excessive use of water can damage wooden floors. Always keep the amount of water used to a minimum. Use a damp mop rather than wet.

Regular Cleaning

Dry sweep or vacuum floors, then clean weekly using Woca Natural Soap.

Maintenance

When the floor is starting to show signs of wear and needs freshening up, clean as above and, once dry, apply a fresh layer of Woca Oil Refreshing Soap - once a month will be sufficient. To keep floors revitalised and looking their best apply Woca Maintenance Gel every six months.

What is the dilution rate for the Woca Oil Refreshing Soap?

The measurements can be increased depending on the wear of the surface but usually we recommend for oiled floors, mixing 250ml of Woca Oil Refreshing Soap with 5 litres of warm water or for UV-oiled and hard wax oiled floors, mixing 125ml of Woca Oil Refreshing Soap with 5 litres of warm water.