Morrells Two-Part Coloured Wood Fillers

Looks grey when dry, goes deep black once polished / oiled / varnished. Not particularly smooth - i.e. has a slightly grainy finish even when finished with 300 grit.

For novices, trying to read the instructions on the very small tube of hardner, was impossible. Perhaps a paper with the amounts to use, would be helpful ?

Morrells Two-Part Coloured Wood Fillers are a great addition to my workshop. I use them in live edge furniture before finishing. The range of colours enables me to sort out blemishes in most timbers.

This is no doubt a very good wood filler but once mixed it dries in a few minutes. I was trying to repair rotten timber on the front elevation of my house and by the time I had climbed the ladder the wood filler had started to dry making it difficult to get a smooth finish.

Easy to use, goes along way and great colour match

Great product for the job I was working on

Worked really well on fixing the giant holes (2.5 x 2 x 2.5cm) make by insects in the top edge of my cedar wood hot tub!! Didn’t like the colour though hence only 3*

I wouldn’t buy anything else after using the resin

This product is new to me but so useful on exterior woodwork which is going to be dark stained (Sadolin Jacobean Walnut). Rather more fluid and hence workable than the alternatives, and easier to sand down; if it proves as resilient and weatherproof as them I shall make this my go-to brand.

Very few companies do a medium oak, you can normally only find light or dark.

Has added years of life to our shed

Was easy to apply and sand down

Good product but very volatile wearing a mask is essential

Good to use,very pleased with results

A great product, easy to use, hard wearing however the colours aren't as you'd imagine... a bit light for a pine...

Easy to use although the measurements for the mix quantities were a little obscure. Once mixed, it set in a reasonable time, could be smoothed adequately and responded well to final sanding. The match to my mahogany window ledge is excellent when Sadolin was applied. Only time will tell if this product is durable.

Good colour match, Good value, Easy to use!

Both fillers are good and easy to use.

The best wood filler I used so far

Did the job. Great colour match. Eezy peezy

It has filled gaps in the floor well. Hopefully it stands up over time.

Not as smooth as other fillers and was quite sensitive to hardner ratio to paste. Too little and it would not cure. However it comes in a good range of colours.

Does what it says on the tin...

I bought this to fill the screw holes in my black painted wooden picket fence. I'd previously used a wood filler from a certain DIY store but had to paint over with several coats of paint as I couldn't get black! This product has saved me loads of hassle, it's a really strong black and stays workable for a good time so no waste! Perfect!

Bought this for some repairs prior to re staining some garage door frames. It is wetter than other 2 part fillers I have used which was a little tricky to use at first, but thankfully it didn't slump. I used a geared eccentric and also a detail sander to finish. The repairs are really tough, and after staining and varnishing they looked brilliant. I am impressed with the filler and my client is impressed with the end result.

I used this product to fill a number of holes in my worktop. It was easy to use and I was very impressed with the results

I haven't used the ash yet, but did use the black. It dries fairly quickly when mixed so think about this when getting ready to use it. Iused it as a grain filler and it worked fine.

Product went on easily with good coverage. Reasonably priced. Would use again

I has only been a few months since I applied this to my floor but this product was recommended by my friend who does wood flooring professionally and so far so good. I am very pleased with the finish. Will use it again if and when I do more home improvement projects which involve wood floors.

High quality product with plenty of hardener. Very impressed.

Could have done with larger hardner tube. This is common for all two part mixes, in my experience.

This is probably an excellent product, if you can work with fairly large batches. I was trying to fill some fiarly small gaps in an oak worktop, using about 25gms of filler at a time. However, trying to get the right amount of hardener for that amount of filler is very dificult - trial and error showed it had to be pretty accurately measured, and getting just 0.625gms of hardener measured was pretty much impossible. Needs a different hardener so that the ratio of hardener to filler could be nearer 25% instead of 2.5%

After mixing gave a good 10 mins working time to apply. Dried hard and could be sand-papered.