V33 Renovation Wall Tile and Panelling

V33 Renovation Wall Tile and Panelling is an enduring water resistant paint designed to refurbish high traffic and high moisture areas. With no need to use an undercoat, the aquaresist technology obstructs water penetration and fortifies resistance to shampoos, soap and household cleaning products.

Looking for renovation products for other areas of the home? Why not try:

• V33 Renovation Cupboard and Cabinet
• V33 Renovation Radiator and Household Appliance
• V33 Renovation Floor and Stairs

To achieve optimum results, the surface needs to be structurally sound, clean and free from any impairments, such as dirt, dust and grease.

• Any aged, peeling or defective paint needs to be removed either by sanding or with the use of a paint scraper
• Extra care should be taken if preparing pre-1960s painted surfaces as they may possibly contain dangerous quantities of lead
• Remove all organic growth, such as algal, fungal mould or lichen growths, with an antifungal solution
• If required, clean any dirt, grease and dusty or powdery residues by washing the area with a suitable detergent
• Any Surface flaws, such as small holes and cracks will need to be be plugged and sealed with an appropriate filler
• If being applied to panelling, it is recommended to slightly abrade the surface with 240 grit to provide a key to aid adhesion
• Untreated wooden products that have oils/extractives need cleaning with methylated spirits and treat any knots with two coats of fresh knotting
• It is advisable to use an appropriate undercoat if being applied to Oak or raw Chestnut wood to block any tannin
• If being applied to a tiled area, carefully clean the grouting with an abrasive sponge to remove any residual cleaning products
• It is strongly recommended to wash the surface with a sodabased or sugar soap (alkaline) cleaner, focusing on the grouting
• If required, rub down surfaces and then wipe off with a damp, lint-free cloth to remove dust

Remove any silicon sealant before applying the paint and then reseal after the application

Always perform a test area ahead of applying to judge the appropriateness of the product and the final finish. Follow the manufacturer's instructions on the tin at all times.

To ensure the consistency of colour, purchase enough V33 Renovation Wall, Tile and Panelling for each project including an adequate amount for touch-in at a later date.

Avoid application when air or surface temperatures are likely to fall below 12ºC or surpass 25ºC during the application or the drying period and avoid or block any draughts

• Uncover the additive sachet under the lid and pour the contents into the paint. Blend and stir the paint with the additive for a minimum of 5 minutes, making certain to work through the edges and the bottom of the tin, ensuring consistency throughout the paint
• Apply V33 Renovation Wall, Tile and Panelling with a high quality 4-5mm pile roller and a round edged synthetic brush
• It is suggested to work in small areas using the "wet edge" technique and successive cross strokes to ensure a consistent opacity and high quality results
• The normal finishing process requires 2 full coats of V33 Renovation Wall Tile and Panelling, however this can vary if applied over a dark surface

Once the additive sachet has been mixed into the paint, the mixture must be used within 10 days to retain optimal adhesion and performance

To clean your painted surfaces, it is recommended to use a cloth with a mild detergent

Optimum performance of V33 Renovation Wall Tile and Panelling is achieved 20 days after the application. Treat the surface gently, avoiding direct impact, abrasion, staining or cleaning, for the first 20 days after application