The Cuprinol Fence & Decking Power Sprayer is ideal for a wide range of applications and can be used in conjunction with Cuprinol One Coat Sprayable Fence Treatment.
Please Note: The spray may not emerge immediately as it takes up to a minute for the fluid to reach the nozzle. Do not run the sprayer dry (i.e. without water or product) as this can damage the sprayer, and do not look down the nozzle whilst the sprayer is switched on.
This sprayer has a very controlled spray pattern, however, as with any spray product, a limited amount of overspray will be created. This can be minimised by avoiding spraying in windy conditions and by using cardboard or plastic as a shield.
Masking off windows, doors, patios, brickwork, gutters, downpipes, fascias, drains and plants is recommended when spraying outdoor buildings, such as sheds and summerhouses. Any overspray should be cleaned up immediately, whilst still wet, with water and household detergent if necessary. Excessive spillage on plants should be rinsed off immediately before drying.
If the Fence & Decking Power Sprayer stops spraying, check if the batteries need changing, if the nozzle has become blocked or if an airlock has occurred. Do not tamper with the sprayer when it is switched on at any stage.
Any unused fluid can be removed from the Cuprinol Fence & Decking Power Sprayer and retained for future use. Simply unscrew the tank cap from the pump body and pour the remaining product back into the original fluid container.
See Technical Information Datasheet above for more Troubleshooting information and other information related to this product.
Please Note: Do not leave the sprayer filled with water or product when not in use or overnight. Remove batteries before cleaning sprayer top (upper housing). Clean with water only, do not use White Spirit or other solvents.
Please Note: Do not use wire, pins or similar sharp objects to clean or unblock the nozzle, as this will lead to damage and a poor spray pattern, and do not allow product to dry, as this will block nozzle.
Remove suction pipe and inlet filter and clean under running water with a soft brush to ensure all product is removed, especially from the inlet filter