Barrettine Teak Oil

Barrettine Teak Oil is natural oil ideal for retaining the natural beauty of hardwood garden furniture, such as Teak. Perfect for feeding, nourishing and reviving the look of the wood, reducing the effects of weathering.

• Also available in a handy trigger spray applicator - Barrettine Teak Oil Spray is perfect for regular maintenance
• For an alternative wood oil for garden furniture, try Barrettine Garden Furniture Oil
• Looking for other traditional wood oils? Try Barrettine Danish Oil, Barrettine Boiled Linseed Oil or Barrettine Raw Linseed Oil

Areas to be treated should be clean, dry and free from traces of dust, dirt, grease, wax and silicone.

Exterior Wood

Bare or Untreated Wood

1. Clean the wood to be oiled with a stiff broom or brush to remove all traces of surface dirt and debris
2. For areas affected by mould, algae or moss, use Barrettine Mould and Mildew Cleaner
3. Treat with a suitable exterior wood preservative for the best protection
4. If possible, preserve all sides including end grain prior to installation
5. Wipe down new wood with Meths such as Barrettine Methylated Spirits and allow to dry

Previously Finished Wood

Old coating type finishes such as paints, varnishes and varnish-type stains must be fully removed back to bare wood before oiling. Depending on the condition and type of finish, it may require more than one attempt to fully remove the old coating.

1. Ensure that all 'coating' type finishes have been fully removed to expose bare wood by either jet washing or using a dedicated paint stripper / remover
2. Old oiled finishes should be lightly sanded or cleaned thoroughly with white spirit

Once the old finish has been completely removed / cleaned, refer to the preparation instructions for bare or untreated wood above.

Interior Wood

1. Existing oiled surfaces can be lightly cleaned if required with a dedicated wood cleaner
2. Pre-existing varnishes and sealers must be completely removed via sanding or using a suitable product stripper / remover
3. Use an appropriate wood filler if repairs are required before oiling

Always do a small test area before starting any project to check suitability and compatibility. Follow the manufacturer's instructions on the tin at all times.

1. Apply Barrettine Teak Oil thinly and evenly with a soft, lint-free cloth or a natural bristle brush
2. Work the oil into the wood, finishing off in the direction of the wood grain
3. Remove any excess oil from the surface of the wood after 15 minutes
4. Allow to dry for 24 hours between coats
5. Apply additional coats as required, using the same method described above

Please Note: Barrettine state that Teak Oil is not recommended for use on Oak. This said, however, many of our customers have used Teak Oil on Oak and have been happy with the results.

Maintenance

Additional coats of Barrettine Teak Oil can be applied as and when the finish starts to look tired, worn or if it begins to lose its water resistance. Simply clean the surface first to remove any traces of dust and dirt, then apply a fresh coat of Teak Oil as per the Application instructions above.