Floor Varnish

This is an easily applied water based varnish, designed to give maximum strength and durability after 2-3 light coats to most wooden surfaces including floors, kitchens and table tops etc. It is not too runny, making it easy to apply with a paint brush. In the tub it has a slight peach coloured tint but once on the wood it dries completely clear. As with all non-pigmented products, the colour of your piece will change slightly which most customers say is for the better. It tends to brighten the look a little.

If this Floor Varnish is being applied on top of a water based stain it is advisable to try to use a minimum of brush strokes to avoid dislodging the colour in the stain. This is only necessary when applying the first coat, subsequent coats can be applied as normal.

Another advantage of this product is that it can be tinted using our compatible water based dyes. This could be useful, if for example, a piece has been stained or finished with a lacquer but the colour is not to your liking. Simply add some brown dye to the water lacquer and apply another coat until the right shade is achieved. Further adjustments can be made by adding red, orange, yellow or black if necessary.

At temperatures above 4 degrees C and below 28 degrees C, Extra Tough Water Lacquer will keep for at least a year. As with most water based products avoid temperatures below zero or the water content of the product can freeze!

Please note that if you apply water based varnishes on top of a water based stain (or dye) then the water in the varnish can dislodge the water in the stain, which could result in a patchy finish. The way around this happening is to use a minimum of brush strokes, preferably passing the brush over the surface in one direction. However this only needs to be done for the first layer of varnish. Subsequent coats can be applied as normal. Spraying will also avoid this problem from occurring.

This product is very easy to apply with a roller, flooring brush or spray gun. Wash any used applicator in warm water or methylated spirits immediately after use.

Spraying Information

Most spray systems can be used for this product but they can become blocked if any lacquer is left inside and the machine is unused for extended periods. If this happens a spray through with warm water will normally do the trick but if not use an alcohol thinner or methylated spirit (Not white spirit).

Container Sizes and coverage

Approx 10 Square metres per litre depending on the temperature, amount applied and the type of wood being worked on.

Uses

For any surface requiring good protection or strong water repellancy. Please note that a 2 pack water lacquer is available for even greater strength.

Drying Time

A medium coat will be touch dry within 1 hour although the curing time is 12-24 hours (before the surface can be used).