Barrettine Mould and Mildew Cleaner 4L

  4.7/5.0   42 reviews
 
COVERAGE CALCULATOR
 x 
You'll need enter area above for 1 coat (Usually sufficient)
You'll need enter area above for 2 coats (Sometimes necessary)

Wood type and application can vary coverage

 
  • An effective multicide, fungicidal wash for the control of mould, algae and fungi
  • For use on most surfaces including timber, concrete, brick, plaster, stone and tiles
  • Perfect for interior and exterior use
  • Ready-to-use from the container
  • Contains biocide for the control of organic growths
  • Low odour
Brand Barrettine
No. of coats 1-2
Coverage Up to 10 per litre
Drying time 24 hrs
Size 4L
MPN MULT004
GTIN 5015861000859

Barrettine Mould & Mildew Remover is perfect for use as a pre-treatment for wood that has developed mould, algae or fungi, prior to the application of a wood oil or other wood finish. Also contains cleaning ingredients to remove light surface dirt from plastic, wood and other substrates but does not contain bleach.

Looking to clean your driveway, decking and patio areas? Barrettine Driveway, Decking and Patio Cleaner is perfect for the job.

Learn more about how to keep your decking looking fantastic on our blog.

Why not take a look at the second blog post in our series of three about wooden decking maintenance, preparation and preservation?

Before applying Barrettine Mould and Mildew Cleaner, remove as much surface dirt, debris and organic growth as possible with a scraper, stiff brush or broom.

Always do a small test area before starting any project and follow the manufacturer's instructions on the container at all times.

For maximum biological effectiveness it is recommended that Barrettine Mould & Mildew Cleaner is applied to dry surfaces.

This product can be applied by brush, roller or re-used kitchen spray bottle at a rate of 5 to 10 meters square per litre, depending on how porous the surface to be treated is.

Only use Barrettine Mould and Mildew Cleaner when the surface and ambient air temperature is above 5℃.

  1. Apply by brush, roller or spray
  2. Scrub the treated areas and leave to dry for 20 minutes
  3. When dry, rinse off all substance
  4. Repeat if necessary (2nd application not normally required)
  5. The wood is now ready for finishing

To maximise biocidal effect, follow same instructions as above, however leave for 24 hours to dry before washing off.

Once the wood has been treated and cleaned with Barrettine Mould and Mildew Cleaner it is ready to be treated with a wood preserver to protect against future infestations and finished with an appropriate wood oil, paint or stain.

42 customer reviews
4.7/5.0